LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Forester X, Standard >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System - Seats >> Rear Seat >> Removal

Rear Seat: Removal

CAUTION: The satellite safing sensor of the airbag system is installed under the center of the rear seat cushion. Read the cautions and warnings indicated in the AB article before removing the rear seat. Refer to CAUTION , General Description.
  1. Remove the cap behind the seat table and disconnect the connector. (Models with seat table)
  2. Remove the bolt. (Models with seat table)
    Fig 1: Identifying Rear Seat Bolts
    G05957913Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the three hooks while lifting up the rear seat cushion.
    Fig 2: Lifting Up Rear Seat Cushion
    G05663660Courtesy of SUBARU OF AMERICA, INC.
    NOTE: There are two hook locations on the seat table.
    Fig 3: Locating Hook On Seat Table
    G05022762Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the hook (A) by pushing it back while lifting the front side of the seat cushion, and remove the seat cushion.
    Fig 4: Identifying Front Side Seat Cushion Hook
    G05957916Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the headrest, and then tilt the backrest forward.
  6. Remove the luggage floor mat.
  7. Turn over the mat and remove the bolts.
    Fig 5: Locating Mat Bolts
    G05004345Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the backrest from hinge assembly LH (hinge assembly RH).
    Fig 6: Removing Backrest From Hinge Assembly LH
    G05022770Courtesy of SUBARU OF AMERICA, INC.
    NOTE: The backrest cannot be detached while the hinge assembly side and the backrest pin are not aligned.
  9. Remove the reclining button.
    CAUTION: Use the following procedures to remove the reclining button. Damage to the reclining button may result if the procedures are not followed correctly.
    1. Remove the weather strip, and insert a flat-head screwdriver into the rear of the rear seat backrest shoulder.
    2. Press the tab on the rear side of the reclining button downwards and remove the reclining button.
    CAUTION: Do not press strongly on the button tab. Pressing with excessive force may break the tab.
    Fig 7: Inserting Screwdriver Into Rear Of Rear Seat Backrest Shoulder
    G05957919Courtesy of SUBARU OF AMERICA, INC.
    Fig 8: Removing Reclining Button
    G05957920Courtesy of SUBARU OF AMERICA, INC.
    NOTE:
    • Direct a light from under the rear seat backrest shoulder to easily identify the tab position.
    • The LH side is left and right symmetrical.
  10. Remove the nut, and remove the rear seat backrest shoulder.
Fig 9: Locating Rear Seat Backrest Shoulder Nut
G05957921Courtesy of SUBARU OF AMERICA, INC.