LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Forester X, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - Brakes - Mechanical >> Brake Pipe >> Installation

Brake Pipe: Installation

NOTE: The airbag system wiring harness is routed near the center brake pipe.
CAUTION:
  • Airbag system wiring harness and connectors are colored yellow. Do not use the electrical test equipment on these circuits.
  • Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
  • When installing the brake pipe, do not bend.
  • After installing the brake pipe and hose, perform air bleed.
  • After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc.

Brake pipe tightening torque: 

Refer to "COMPONENT" of "General Description"  . Refer to FRONT BRAKE PIPES AND HOSES , COMPONENT, General Description . Refer to CENTER AND REAR BRAKE PIPES AND HOSES , COMPONENT, General Description .

scientia non olet · About LEMON Manuals