Rear Brake Hose

Route the brake hose through the hole of bracket, and lightly tighten the flare nut to connect brake pipe.
Insert the clamp to secure brake hose.

Fig 1: Identifying Brake Pipe, Brake Hose And Brake Hose Clamp
Courtesy of SUBARU OF AMERICA, INC.
Install the brake hose to rear brake caliper using a new gasket.
Tightening torque:

Union bolt

18 N.m (1.8 kgf-m, 13.0 ft-lb)

Brake hose bracket

33 N.m (3.4 kgf-m, 24.3 ft-lb)

Fig 2: Locating Brake Hose Bracket Bolts
Courtesy of SUBARU OF AMERICA, INC.
Tighten the flare nut to the specified torque.
Tightening torque (brake pipe flare nut):

15 N.m (1.5 kgf-m, 10.8 ft-lb)
Bleed air from the brake system.