LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Tribeca Limited >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - Brakes - Mechanical >> Rear Disc Brake Assembly >> Assembly

Rear Disc Brake Assembly: Assembly

  1. Clean the inside of the caliper body using brake fluid.
  2. Apply a coat of brake fluid to piston seal and install piston seal in the groove on caliper body.
  3. Apply a coat of brake fluid to the inner surface of cylinder and the entire outer surface of the piston.
  4. Apply a coat of specified grease to the boot and fit to the groove on the ends of cylinder.

    Grease: 

    NIGLUBE RX-2 (Part No. 000041000) 

  5. Insert the piston into cylinder.
    CAUTION: Do not force the piston into cylinder.
  6. Position the boot in the grooves on piston and cylinder.
    Fig 1: Identifying Piston Boot, Piston, Caliper Body And Cylinder
    G05671290Courtesy of SUBARU OF AMERICA, INC.
  7. Apply a coat of specified grease to the guide pin, outer surface, sleeve outer surface, cylinder inner surface, and boot grooves.

    Grease: 

    NIGLUBE RX-2 (Part No. 000041000) 

    Fig 2: Identifying Pin Boot, Lock Pin And Guide Pin
    G05671291Courtesy of SUBARU OF AMERICA, INC.
  8. Install the guide pin boot to the support.
  9. Install the lock pin boot to support, and then insert the lock pin sleeve into the specified position.
scientia non olet · About LEMON Manuals