Rear Brake Pad: Installation

Apply a thin coat of Molykote M7439 (Part No. K0770YA000) to the pad clip.

Fig 1: Applying Thin Coat Of Molykote M7439 To Pad Clip
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the contact surface between the pad and shim.

Fig 2: Applying Thin Coat Of Molykote AS880N Between Pad And Shim
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to both surfaces of pad inner shim.

Fig 3: Applying Thin Coat Of Molykote AS880N To Both Surfaces Of Pad Inner Shim
Courtesy of SUBARU OF AMERICA, INC.
Install the pad to support.
Install the caliper body to the support.
Tightening torque:

27 N.m (2.8 kgf-m, 19.9 ft-lb)
Install the brake hose bracket.
Tightening torque:

33 N.m (3.4 kgf-m, 24.3 ft-lb)