Front Brake Pad: Installation

Apply a thin coat of Molykote M7439 (Part No. K0770YA000) to the pad clip.

Fig 1: Applying Thin Coat Of Molykote M7439 To Pad Clip
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the contact surface between the pad and pad inner shim.

Fig 2: Applying Thin Coat Of Molykote AS880N Between Pad And Pad Inner Shim
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the three contact surfaces between inner shim and outer shim of outer pads.

Fig 3: Applying Thin Coat Of Molykote AS880N Between Inner Shim And Outer Shim Of Outer Pads
Courtesy of SUBARU OF AMERICA, INC.
Install the pad to support.
NOTE: Install the pad indicator in proper direction.

Fig 4: Identifying Pad To Support
Courtesy of SUBARU OF AMERICA, INC.
CAUTION:
- Be sure to install so that the pad return spring faces the input side of the direction of brake rotor rotation, as shown in the figure.
- Correctly install the pad return spring to the supporting surface of the pad clip as shown in the figure.
- If the pad return spring is deformed or damaged, replace the brake pad.
  
  Fig 5: Identifying Rotor Rotation Direction
  Courtesy of SUBARU OF AMERICA, INC.
Install the caliper body to the support.
Tightening torque:

27 N.m (2.8kgf-m, 19.9 ft-lb)