Installation

TRANSMITTER (CLAMP IN TYPE)
1) Install the transmitter to the wheel by aligning it with valve hole, and then tighten with nuts.





Tightening torque: 7.5 N-m (0.76 kgf-m, 5.53 ft-lb)
2) Install the tires to wheels.

CAUTION:
^ Use a tire changer when installing tire to wheel.
^ To prevent damaging the transmitter, set the tire changer boom in the position as shown in the figure.





3) Install the wheels to vehicle.
4) Register the transmitter ID to the tire pressure monitoring control module.

TRANSMITTER (SNAP IN TYPE)

CAUTION: Use the new transmitter assembly or replace the new valve and screw, when installing.

1) Replace the valve and screw with a new part when reusing transmitter.





Tightening torque: 1.4 N-m (0.1 kgf-m, 1 ft-lb)
2) Install the transmitter to the wheel by aligning it with valve hole.
3) Install the tires to wheels.

CAUTION:
^ Use a tire changer when installing tire to wheel.
^ To prevent damaging the transmitter, set the tire changer boom in the position as shown in the figure.





4) Install the wheels to vehicle.
5) Register the transmitter ID to the tire pressure monitoring control module.