LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis (Single Page) >> Brakes >> Parking Brake System >> Parking Brake System >> Parking Brake Assembly (Rear Disc Brake) >> Adjustment >> Shoe Clearance

Shoe Clearance

  1. Return the parking brake lever fully.
  2. Remove the adjusting hole cover from back plate.
  3. Turn the adjusting screw using a flat tip screwdriver until the brake shoe is in close contact with disc rotor.
    Fig 1: Removing Adjusting Hole Cover From Back Plate
    G03833040Courtesy of SUBARU OF AMERICA, INC.
  4. Turn back (downward) the adjusting screw 3 to 4 notches.
    CAUTION: Check there is no brake drag.
  5. Install the adjusting hole cover to back plate.
  6. Adjust the parking lever stroke. < Ref. to LEVER STROKE  , ADJUSTMENT, Parking Brake Assembly (Rear Disc Brake). >
scientia non olet · About LEMON Manuals