LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim & Interior Trim >> Rear Shelf Trim >> Removal

Rear Shelf Trim: Removal

  1. Disconnect the ground cable from the battery.
  2. Remove the rear quarter trim. < Ref. to SEDAN MODEL , REMOVAL, Rear Quarter Trim. >
  3. Remove the high-mounted stop light. < Ref. to REMOVAL , High-mounted Stop Light . >
  4. Remove the rear seat cushion. < Ref. to WAGON MODEL , Rear Seat . >
  5. Remove the lower anchor bolt of the rear center seat belt.
    Fig 1: Identifying Lower Anchor Bolt Of Rear Center Seat Belt
    G05023033Courtesy of SUBARU OF AMERICA, INC.
  6. After disconnecting the high-mounted stop light harness connector (A) and removing the five clips, remove the rear shelf trim by pulling it frontward.
    Fig 2: Identifying High-Mounted Stop Light Harness Connector
    G05023034Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals