LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Mechanism & Function - Instrumentation & Driver Information Center >> Combination Meter >> Diagnosis Mode >> Procedure >> Entering diagnosis mode

Entering diagnosis mode

  1. Connect the diagnosis connector.
  2. Turn ON the ignition switch.
  3. During initial operation of the meter and while the needle is moving, push the trip knob once to enter diagnostic trouble code display mode, or push the knob twice to enter self diagnosis mode.
NOTE: If the vehicle is driven while in diagnosis mode (vehicle speed signals input), diagnosis mode is cancelled.
scientia non olet · About LEMON Manuals