With 17" Wheel

Install the support on housing.
Tightening torque:

80 N.m (8.2kgf-m, 59 ft-lb)
Apply a thin coat of Molykote M7439 to pad clip.

Fig 1: Locating Molykote M7439 Applying Point (17 Inch)
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the frictional portion between pad and inner shim.

Fig 2: Locating Molykote AS880N Applying Point (1 Of 2) (17 Inch)
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No. K0779YA010) to the three frictional portions between inner shim and outer shim of outer pads.

Fig 3: Locating Molykote AS880N Applying Point (2 Of 2) (17 Inch)
Courtesy of SUBARU OF AMERICA, INC.
Install the pad on support.
NOTE: Install the pad indicator in proper direction.

Fig 4: Identifying Brake Pad Indicator Installation Proper Direction
Courtesy of SUBARU OF AMERICA, INC.
CAUTION:
- Correctly install the pad return spring to supporting surface of pad clip as shown in Fig 5 .
- When the pad return spring is deformed or damaged, replace the brake pad with new one.
Fig 5: Installing Pad Return Spring
Courtesy of SUBARU OF AMERICA, INC.
Install the caliper body on support.
Using new brake hose gaskets, connect the brake hose.
Tightening torque:

18 N.m (1.8 kgf-m, 13.0 ft-lb)
Bleed air from brake system.