LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Forester XT, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - Brakes - Mechanical >> Rear Disc Brake Assembly >> Disassembly

Rear Disc Brake Assembly: Disassembly

  1. Remove the boot ring.
    Fig 1: Removing Boot Ring
    G05327347Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the piston boot.
    Fig 2: Removing Piston Boot
    G05032785Courtesy of SUBARU OF AMERICA, INC.
  3. Place a wooden block in caliper body as shown in the figure to prevent the piston from jumping out and being damaged, then gradually apply compressed air via installation hole of brake hose to push piston out.
    Fig 3: Placing Wooden Block In Caliper Body
    G05327349Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the piston seal from caliper body cylinder.
    CAUTION: Do not damage the caliper body cylinder and piston seal groove.
    Fig 4: Removing Piston Seal From Caliper Body Cylinder
    G05032787Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the lock pin sleeve and pin boot from caliper body.
  6. Remove the guide pin (green) and pin boot.
scientia non olet · About LEMON Manuals