LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Forester XT, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - Brakes - Mechanical >> Hill Holder >> Installation >> PHV (Pressure Hold Valve)

PHV (Pressure Hold Valve)

  1. Attach the PHV to the side frame.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.0 ft-lb) 

  2. Connect the brake pipe to the PHV.

    Tightening torque: 

    15 N.m (1.5 kgf-m, 10.8 ft-lb) 

    CAUTION: Check that there is no deformation or damage on the brake pipe. If necessary, replace with a new part.
  3. Attach the PHV cable to the PHV.
    CAUTION:
    • If the cable clamp (and clip) is damaged, replace it with a new part.
    • Do not bend the PHV cable sharply to avoid damage.
  4. Connect the PHV cable with a clip.
  5. Apply grease to the following points.
    • Return spring hook position
    • Lever cable end portion.

    Grease: 

    KOPR-KOTE (Part No. 003603001) 

  6. Bleed air from the brake system. <Ref. to AIR BLEEDING . >
  7. Adjust the PHV cable. <Ref. to PHV CABLE , INSTALLATION, Hill Holder. >
    CAUTION: After replacing with a new PHV cable, operate the clutch pedal approximately 30 times to break it in, then perform adjustment.
scientia non olet · About LEMON Manuals