LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Forester XT, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - Brakes - Mechanical >> Brake Pedal >> Removal >> At Model

At Model

  1. Disconnect the ground cable from the battery.
  2. Remove the instrument panel lower cover from instrument panel.
  3. Remove the clevis pins which secure the brake pedal to the brake booster operating rod. Also disconnect the stop light switch connector.
  4. Remove the two bolts and four nuts which secure brake pedal to pedal.
    Fig 1: Identifying Clevis Pin And Snap Pin To Brake Booster Operating Rod
    G05327401Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals