LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Forester X, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - Brakes - Mechanical >> Rear Disc Brake Assembly >> Removal

Rear Disc Brake Assembly: Removal

CAUTION: Do not let brake fluid come into contact with the painted surface of the vehicle body. Completely wash away with water immediately and wipe off if it was accidental.
  1. Set the vehicle on a lift.
  2. Loosen the wheel nuts.
  3. Lift-up the vehicle, and then remove the rear wheels.
  4. Disconnect the brake hose from caliper body assembly.
  5. Remove the bolt securing lock pin (Yellow) to caliper body assembly.
    Fig 1: Identifying Bolt Securing Lock Pin To Caliper Body Assembly
    G05327346Courtesy of SUBARU OF AMERICA, INC.
  6. Raise the caliper body, and then move it toward vehicle center to separate it from the support.
  7. Remove the support from housing.
    NOTE: Remove the support only when replacing the rotor or support. It need not be removed when servicing the caliper body assembly.
  8. Remove mud and foreign matter from caliper body assembly and support.
    CAUTION: Be careful not to allow foreign matter to enter the brake hose connector.
scientia non olet · About LEMON Manuals