Front Disc Brake Assembly: Installation

Install the support to the housing.
Tightening torque:

80 N.m (8.2 kgf-m, 59 ft-lb)
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the contact surface between pad and pad clip.
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the contact surface between inner pad and the rubber coat shim.
NOTE:
- Do not apply grease between the outer pad and the outer shim.
- Do not install the inner shim and outer shim incorrectly.
  
  Fig 1: Identifying Grease Apply Area Outer Pad And Outer Shim
  Courtesy of SUBARU OF AMERICA, INC.
Install the pad to support.
Install the caliper body to the support.
Tightening torque:

26 N.m (2.7 kgf-m, 19.2 ft-lb)
Connect the brake hose using the new gaskets.
Tightening torque:

18 N.m (1.8 kgf-m, 13.0 ft-lb)

CAUTION: When connecting the brake hose, do not twist it.
Bleed air from the brake system. <Ref. to AIR BLEEDING . >