Backup Lamp Switch: Service and Repair

Back-up Light Switch

REMOVAL
1) Remove the manual transmission assembly from the vehicle.
2) Disconnect the back-up light switch connector.





3) Disconnect the back-up light switch.





INSTALLATION
1) Install the back-up light switch.

NOTE: Use a new gasket.





2) Connect the back-up light switch connector.





3) Install the manual transmission assembly to the vehicle.

INSPECTION
1) Disconnect the ground cable from battery.
2) Disconnect the transmission harness and chassis harness.





3) Measure the resistance between the back-up light switch terminals. If it is not within the specification, replace the back-up light switch.