LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake Vacuum Control (Diagnostics) >> Subaru Select Monitor >> Operation >> Function Check Mode

Function Check Mode

  1. Connect the test mode connector located under the glove box.
    Fig 1: Identifying Test Mode Connector
    G05346754Courtesy of SUBARU OF AMERICA, INC.
  2. Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
  3. On the «Main Menu» display screen, select the {Each System Check}.
  4. On the «System Selection Menu» display screen, select the {Brake Negative Pressure Pump System}.
  5. Select the [OK] after the {3.0 DOHC} is displayed.
  6. On the «Negative Pressure Pump Diagnosis Menu» display screen, select the {Function Check Mode}.
  7. When the "Start Function Check Mode" is shown on the screen, select the [OK].
  8. When the "Depress the Brake Pedal 5 Times" is shown on the screen, depress the brake pedal 5 times, and select the [OK] while brake pedal is not depressed.
  9. Select the [OK] after the {OK} is displayed.
scientia non olet · About LEMON Manuals