LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Accessory Drive Belts >> Engine Mechanical (H6DO) >> Oil Switching Solenoid Valve >> Removal

Oil Switching Solenoid Valve: Removal

  1. Disconnect the ground cable from the battery.
  2. Remove the air intake chamber. <Ref. to REMOVAL , Air Intake Chamber .>
  3. Disconnect the connector from oil switching solenoid valve.
    Fig 1: Identifying Connector And Oil Switching Solenoid Valve
    G05018827Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the oil switching solenoid valve.
  5. Remove the variable valve lift diagnosis oil pressure switch. <Ref. to REMOVAL , Variable Valve Lift Diagnosis Oil Pressure Switch .>
  6. Remove the oil temperature sensor. <Ref. to REMOVAL , Oil Temperature Sensor .>
  7. Remove the oil flow control solenoid valve holder from cylinder head.
    Fig 2: Identifying Oil Flow Control Solenoid Valve Holder And Cylinder Head
    G05018828Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals