Rear Brake Hose

Install the brake hose bracket.
Tightening torque:

33 N.m (3.4 kgf-m, 24.3 ft-lb)

Fig 1: Identifying Brake Hose Bracket Bolt
Courtesy of SUBARU OF AMERICA, INC.
Connect the brake hose to the brake pipe.
Insert the clamp to secure brake hose.

Fig 2: Identifying Brake Pipe, Brake Hose And Brake Hose Clamp
Courtesy of SUBARU OF AMERICA, INC.
Install the brake hose to rear brake caliper using a new gasket.
Tightening torque (union bolt):

18 N.m (1.8 kgf-m, 13.0 ft-lb)

Fig 3: Installing Brake Hose To Rear Brake Caliper
Courtesy of SUBARU OF AMERICA, INC.
Tighten the flare nut to the specified torque.
Tightening torque (brake pipe flare nut):

15 N.m (1.5 kgf-m, 10.8 ft-lb)
Bleed air from the brake system.