LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels >> Front Door >> Adjustment

Front Door: Adjustment

  1. Using the ST, loosen the body-side bolts of upper and lower hinges to align the position for vertical and horizontal direction of the front door panel.

    ST 925610000 DOOR HINGE WRENCH

    Fig 1: Identifying Door Hinge Wrench
    G05004581Courtesy of SUBARU OF AMERICA, INC.
  2. Loosen the screw (A) and tap striker (B) using plastic hammer to adjust the gap between rear end surface of front door panel and front end surface of rear door.
CAUTION: Do not use an impact wrench. Welding area on the striker nut plate is easily broken.
Fig 2: Identifying Door Striker
G05004582Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals