LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat System - Seats >> Front Seat >> Removal >> Passenger's Seat

Passenger's Seat

CAUTION: Refer to "CAUTION" of "General Description" before starting the work. <Ref. to CAUTION , General Description.>
  1. Remove the headrest.
  2. Tilt the backrest forward, and move the seat forward.
  3. Remove the rear leg cover, and remove the bolt at the rear side of the slide rail.
  4. Move the seat backward, remove the front leg cover, and then remove the bolt at the front side of the slide rail.
  5. Disconnect the ground cable from battery, and wait for more than 20 seconds before starting work.
  6. Disconnect all the connectors of connector holder in the backside of seat cushion.
    • Harness connector of occupant detection control module
    • Side airbag connector
    • Power seat connector
    • Seat heater connector
  7. Remove the seat from vehicle.
scientia non olet · About LEMON Manuals