LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System >> Headlight Bulb >> Removal >> High Beam And Low Beam

High Beam And Low Beam

CAUTION:
  • Because the halogen bulb operates at a high temperature, dirt and oil on the bulb surface reduces the bulb's service life. Hold the flange portion when replacing the bulb. Never touch the glass portion.
  • Do not leave the headlight without a bulb for a long time. Dust, moisture, etc. entering the headlight may affect its performance.
  1. Disconnect the ground cable from the battery.
  2. Remove the air intake duct. (When removing the headlight bulb RH).
    Fig 1: Identifying Air Intake Duct Bolt
    G05031150Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the battery. (When removing the headlight bulb LH)
  4. Disconnect the harness connector.
  5. Remove the bulb assembly (A) then remove the high beam. To remove the low beam, remove the back cover (B), and then go to the next step.
    Fig 2: Identifying Bulb Assembly And Back Cover
    G05033357Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the light bulb retaining spring (A) to remove bulb.
    Fig 3: Identifying Light Bulb Retaining Spring
    G05033358Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals