LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior/Interior Trim >> Roof Molding >> Removal

Roof Molding: Removal

  1. Turn over the edge of the roof molding, and remove the inside clips with flat tip screwdriver by sliding as arrow indicates.

    Right side: slide towards the front of the vehicle. Left side: slide towards the rear of the vehicle.

    Fig 1: Identifying Inside Clips
    G05347294Courtesy of SUBARU OF AMERICA, INC.
    Fig 2: Identifying Inside Clips
    G05033742Courtesy of SUBARU OF AMERICA, INC.
  2. Pull the roof molding upward, and remove it from vehicle body.
  3. Remove the roof trim. <Ref. to ROOF TRIM . >
  4. Remove the nuts, and remove the roof carrier attachment.
    Fig 3: Identifying Roof Carrier Attachment Nuts
    G05033743Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals