LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System (Heater, Ventilator And A/C) >> Hose and Tube >> Removal

Hose and Tube: Removal

CAUTION:
  • When disconnecting/connecting hoses, do not apply an excessive force to them. After installing, check that no torsion or excessive tension applied to the hoses.
  • Seal the disconnected hose with a plug or vinyl tape to prevent foreign matter from entering.
  1. Disconnect the ground cable from battery.
  2. Using the refrigerant recovery system, discharge refrigerant. < Ref. to PROCEDURE , Refrigerant Recovery Procedure. >
  3. Remove the evaporator unit mounting bolt (A) and low-pressure hose bracket bolt (B).
  4. Remove the low-pressure hose attaching bolts (C).
  5. Disconnect the low-pressure hose from evaporator unit.
  6. Disconnect the low-pressure hose from compressor.
  7. Remove the low-pressure hose from vehicle.
  8. Remove the high-pressure hose attaching bolt (D).
  9. Disconnect the high-pressure hose from compressor.
  10. Disconnect the high-pressure hose from condenser.
  11. Remove the high-pressure hose from vehicle.
  12. Remove the high-pressure tube attaching bolt (E).
  13. Remove the high-pressure tube from vehicle.
    Fig 1: Identifying High-Pressure Tube
    G05020406
scientia non olet · About LEMON Manuals