LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Emission Control (Aux. Emission Control Devices) (H4SO)) >> Pressure Control Solenoid Valve >> Removal

Pressure Control Solenoid Valve: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from the battery.
    Fig 1: Identifying Ground Cable From Battery
    G05019586
  3. Lift-up the vehicle.
  4. Disconnect connector (A) from the pressure control solenoid valve.
  5. Disconnect the evaporation hose (B) from the pressure control solenoid valve.
  6. Remove the bolts (C) which secure the bracket to the fuel tank.
    Fig 2: Identifying Connector, Evaporation Hose And Bolts
    G05016952
  7. Remove the pressure control solenoid valve from the bracket.
    Fig 3: Locating Pressure Control Solenoid Valve
    G05016953
scientia non olet · About LEMON Manuals