B: Installation

WARNING: This page is about a different variant/trim than selected.

Connect the quick connector on fuel line.
CAUTION:
- If the retainer remains in the pipe after removal, replace the retainer with a new part.
- Make sure there is no damage or dust on the connections. If necessary, clean seal surface of pipe.
  
  Fig 1: Identifying Seal Surface And Pipe
1. Set the new retainer (B) to connector (A).
2. Push the pipe into the connector completely.
  
  Fig 2: Identifying Connector, Retainer And Pipe
CAUTION:
- Pull the connector to ensure it is connected securely.
- Make sure the two retainer claws are engaged in their mating positions in the connector.
- Be sure to inspect hoses and their connections for any leakage of fuel.
  
  Fig 3: Pulling Connector
Connect the fuel delivery hose to the pipe with an overlap of 20 to 25 mm (0.79 to 0.98 in). Type A: When the amount of inserting is specified. Type B: When the amount to be inserted is not specified.
l: 2.5±1.5 mm (0.098±0.059 in)

L: 22.5±2.5 mm (0.886±0.098 in)

CAUTION: Be sure to inspect hoses and their connections for any leakage of fuel.

Fig 4: Identifying Fuel Hose Length
Connect the evaporation hose to the pipe with an overlap of approx. 15 to 20 mm (0.59 to 0.79 in).
Fuel evaporation hose:

l = 17.5±2.5 mm (0.689±0.098 in)

CAUTION: Be sure to inspect hoses and their connections for any leakage of fuel.

Fig 5: Identifying Hose, Pipe And Clip Length