Reduction Driven Gear: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove the ball bearing from reduction driven gear using ST.
ST 498077300 REMOVER

Fig 1: Identifying Ball Bearing
Remove the ball bearing on the reverse side with the same procedure as step 1).
ST 498077300 REMOVER

Fig 2: Identifying Ball Bearing
Remove the snap ring of the parking gear.

Fig 3: Identifying Snap Ring Of Parking Gear
Using the ST, remove the parking gear.
ST 18767AA000 REMOVER

Fig 4: Identifying Parking Gear Remover