LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Automatic Transmission 5AT) >> Oil Pump Cover >> Removal

Oil Pump Cover: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from vehicle body. < Ref. to REMOVAL , Automatic Transmission Assembly. >
  2. Pull out the torque converter assembly. < Ref. to REMOVAL , Torque Converter Assembly. >
  3. Remove the transmission harness connector from stay.
  4. Remove the oil charge pipe. < Ref. to REMOVAL , Oil Charge Pipe. >
  5. Remove the ATF filter inlet and outlet pipes. < Ref. to REMOVAL , ATF Filter. >
  6. Separate the converter case and transmission case. < Ref. to REMOVAL , Converter Case. >
  7. Remove the oil pump cover mounting bolt, and then separate the oil pump cover from the AT main case by lightly tapping with plastic hammer.
    Fig 1: Identifying Oil Pump Cover Mounting Bolt
    G05022338
scientia non olet · About LEMON Manuals