Read Diagnostic Trouble Code (DTC)

WARNING: This page is about a different variant/trim than selected.

Prepare the Subaru Select Monitor kit.

Fig 1: Identifying Subaru Select Monitor Kit
Connect the diagnosis cable to the Subaru Select Monitor.
Insert the cartridge to the Subaru Select Monitor. < Ref. to PREPARATION TOOL , General Description. >

Fig 2: Inserting Cartridge Into Subaru Select Monitor
Connect the Subaru Select Monitor to the data link connector.
1. Data link connector is located in the lower portion of instrument panel (on the driver's side).
  
  Fig 3: Identifying Data Link Connector
2. Connect the diagnosis cable to the data link connector.
NOTE: Do not connect scan tools except for Subaru Select Monitor or OBD-II general scan tool.
Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor switch ON.

Fig 4: Identifying Power Switch
On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
On the «System Selection Menu» display screen, select the {Transmission} and press the [YES] key.
Press the [YES] key after the information of transmission type is displayed.
On the «Transmission Diagnosis» screen, select {DTC Display}, and then press the [YES] key.

NOTE:

For details concerning the operation procedure, refer to the "Subaru Select Monitor Operation Manual".
For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)".< Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >