Oil Pump: Installation

Install in the reverse order of removal.

Perform the following.

1. Apply liquid gasket to the mating surfaces of oil pump.

   Liquid gasket: 

   Three bond 1215 (Part No. 004403007) or equivalent 

   Fig 1: Applying Liquid Gasket To Matching Surfaces Of Oil Pump

   
2. Replace O-ring (A) with a new part.
3. Apply a coat of engine oil to the inside of oil seal.
   Fig 2: Applying Coat Of Engine Oil

   
4. Position the oil pump, aligning the notched area with crankshaft, and push the oil pump straight.
   CAUTION:

   • Make sure the oil seal lip is not folded.
   • Be careful not to scratch the oil seal when installing oil pump on cylinder block.
5. Install the oil pump.
6. Apply liquid gasket to the three bolts thread. (if the bolts are reused)

   Liquid gasket: 

   Three bond 1324 (Part No.004403042) or equivalent 

   Tightening torque: 

   6.4 N.m (0.65 kgf-m, 4.7 ft-lb) 

   Fig 3: Applying Fluid Packing To Threads Of Bolts