Oil Pan and Strainer: Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Before installing the oil pan, clean the mating surface of oil pan and engine block.
- Make sure that the seals (A) are installed securely on the baffle plate in a direction as shown in the figure below. (Non-turbo model)
- Install the baffle plate.
Tightening torque:
6.4 N.m (0.65 kgf-m, 4.7 ft-lb)
- Install the oil strainer onto baffle plate.NOTE: Replace the O-ring with a new part.
Tightening torque:
10 N.m (1.0 kgf-m, 7.2 ft-lb)
- Apply liquid gasket to the mating surfaces, and install the oil pan.
Liquid gasket:
Three bond 1207C (Part No.004403012) or equivalent
- Tighten the bolt which installs oil pan to engine block.
Tightening torque:
5 N.m (0.5 kgf-m, 3.6 ft-lb)
- Lower the engine onto front crossmember.
- Tighten the nuts which install front cushion rubber onto front crossmember.NOTE: Make sure the front cushion rubber mounting bolts (A) and locator (B) are securely installed.
Tightening torque:
85 N.m (8.7 kgf-m, 63 ft-lb)
- Install the front and center exhaust pipe. < Ref. to INSTALLATION , Front Exhaust Pipe. >
- Install the under cover.
- Lower the vehicle.CAUTION: When lowering the vehicle, lower the lift-up device and wire ropes at the same time.
- Remove the lifting device and wire ropes.
- Attach the pitching stopper.
Tightening torque:
T1: 50 N.m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N.m (5.9 kgf-m, 42.8 ft-lb)
- Install the hood stay holder (A) and radiator upper brackets (B).
- Install the air intake chamber.
< Ref. to INSTALLATION , Air Intake Chamber. >
- Install the air intake duct and air cleaner case. < Ref. to INSTALLATION , Air Intake Duct. > < Ref. to INSTALLATION , Air Cleaner Case. >
- Install the front wheels.
- Connect the battery ground cable to the battery.
- Refill the engine oil. < Ref. to INSPECTION , Engine Oil. >