LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Cooling System (H4SO)) >> Radiator Sub Fan and Fan Motor >> Removal

Radiator Sub Fan and Fan Motor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586
  3. Lift-up the vehicle.
  4. Remove the under cover.
  5. Remove the radiator under cover.
  6. Remove the connector (B) of sub fan motor.
    Fig 2: Identifying Connector Of Sub Fan Motor
    G05017273
  7. Remove the ATF hose from the clip of the radiator sub fan motor assembly. (AT model)
  8. Lower the vehicle.
  9. Remove the air intake duct. < Ref. to REMOVAL , Air Intake Duct. >
  10. Remove the bolts which hold the radiator sub fan shroud to the radiator.
    Fig 3: Locating Radiator Sub Fan Shroud Bolts
    G04988539
  11. Remove the radiator sub fan motor assembly from underneath the vehicle.
scientia non olet · About LEMON Manuals