LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Cooling System (H4SO)) >> Radiator Main Fan and Fan Motor >> Removal

Radiator Main Fan and Fan Motor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586
  3. Lift-up the vehicle.
  4. Remove the under cover.
  5. Remove the radiator under cover.
  6. Disconnect the connector (A) of the main fan motor.
    Fig 2: Disconnecting Connector Of Main Fan Motor
    G05017272
  7. Remove the ATF hose from the clip of the radiator main fan motor assembly. (AT model)
  8. Lower the vehicle.
  9. Disconnect the over flow hose.
  10. Remove the reservoir tank. < Ref. to REMOVAL , Reservoir Tank. >
  11. Remove the bolts which hold the radiator main fan shroud to the radiator.
    Fig 3: Locating Radiator Main Fan Shroud Bolts
    G04997859
  12. Remove the radiator main fan motor assembly.
scientia non olet · About LEMON Manuals