LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission 4AT) >> Transfer Clutch Pressure Test >> Inspection

Transfer Clutch Pressure Test: Inspection

WARNING: This page is about a different variant/trim than selected.

Check the transfer clutch pressure in accordance with the following chart in the same manner as line pressure. < Ref. to LINE PRESSURE TEST . >

ST 498897700 OIL PRESSURE ADAPTER SET

ST 498575400 OIL PRESSURE GAUGE ASSY

NOTE:
  • Before setting to FWD mode, install the spare fuse on the FWD mode switch.
    Fig 1: Identifying Test Plug
    G05021781Courtesy of SUBARU OF AMERICA, INC.
  • If no oil pressure is produced or if it does not change in AWD mode, the control valve body may be malfunctioning. If oil pressure is produced in FWD mode, there is the same problem as the AWD mode.
    TRANSFER CLUTCH PRESSURE TEST REFERENCE

    Range position ON duty ratio (%) Acceleration opening angle (%) Standard transfer clutch pressure kPa (kg/cm2 , psi)
    AWD mode FWD mode
    Manual mode (2nd) 95 Fully opened (100) 1,000 - 1,200 (10.2 - 12.2, 145 - 174) -
    60 Adjust ON Duty ratio to 60%. 500 - 700 (5.1 - 7.1,73 - 102) -
    - Fully closed (0) - 0 (0, 0)
    N or P 5 Fully closed (0) 0 -