LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission 4AT) >> Reduction Driven Gear >> Removal

Reduction Driven Gear: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from vehicle body. < Ref. to REMOVAL , Automatic Transmission Assembly. >
  2. Remove the rear wheel speed sensor, and separate the extension case from transmission case. < Ref. to REMOVAL , Extension Case. >
  3. Set the range select lever to the "P" range.
  4. Lift the crimped section, and then remove the lock nut.
    Fig 1: Identifying Select Lever Ranges
    G05021911Courtesy of SUBARU OF AMERICA, INC.
  5. Using the ST1 and ST2, extract the reduction driven gear.

    ST1 499737000 PULLER

    ST2 899524100 PULLER SET

    Fig 2: Identifying Reduction Driven Gear
    G05021912Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals