Reduction Driven Gear: Installation
WARNING: This page is about a different variant/trim than selected.
- Set the range select lever to the "P" range.
- Using a plastic hammer, install the reduction driven gear assembly and the new washer, and tighten the new drive pinion lock nut.
Tightening torque:
100 N.m (10.2 kgf-m, 73.8 ft-lb)
- After tightening, stake the lock nut securely.
- Join the transmission case and the extension case, and then install the rear vehicle speed sensor. < Ref. to INSTALLATION , Extension Case. >
- Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >