Oil Seal Retainer

WARNING: This page is about a different variant/trim than selected.

Apply ATF to two new oil seals and install them to the oil seal retainer in the proper direction using the ST.
ST 499247300 INSTALLER

Fig 1: Identifying Oil Seal Retainer
Courtesy of SUBARU OF AMERICA, INC.
Apply ATF to a new O-ring an install it to the oil seal retainer using Vaseline. Install the seal to the oil pump housing bore.

Fig 2: Identifying O-Ring
Courtesy of SUBARU OF AMERICA, INC.
Install the oil seal being careful not to damage oil seal lip, and secure it using three bolts.
Tightening torque:

7 N.m (0.7 kgf-m, 5.1 ft-lb)

Fig 3: Identifying Oil Seal Retainer
Courtesy of SUBARU OF AMERICA, INC.