ATF Cooler Pipe and Hose: Installation

WARNING: This page is about a different variant/trim than selected.

Install the oil cooler inlet and outlet pipes with new washers.
Tightening torque:

T1:25 N.m (2.5 kgf-m, 18 ft-lb)

T2:40 N.m (4.1 kgf-m, 29.5 ft-lb)

T3: 44 N.m (4.5 kgf-m, 32.5 ft-lb)

Fig 1: Connecting Connector To Rear Vehicle Speed Sensor
Courtesy of SUBARU OF AMERICA, INC.
Install the ATF cooler pipe to frame.

Fig 2: Identifying ATF Cooler Pipe
Courtesy of SUBARU OF AMERICA, INC.
Connect the ATF cooler hose to the pipe on the transmission side.
NOTE:
- Install so that the hose is not folded over, excessively bent or twisted.
- Insert the hose to the specified position.
  
  Fig 3: Identifying ATF Cooler Hose
  Courtesy of SUBARU OF AMERICA, INC.
Connect the ATF cooler hose to the pipe on the radiator side.
NOTE:
- Install so that the hose is not folded over, excessively bent or twisted.
- Insert the hose to the specified position.
  
  Fig 4: Identifying ATF Cooler Hose
  Courtesy of SUBARU OF AMERICA, INC.
Install the radiator under cover.

Fig 5: Identifying Radiator Under Cover
Courtesy of SUBARU OF AMERICA, INC.
Install the under cover.
Install the battery.
Fill the ATF. < Ref. to AUTOMATIC TRANSMISSION FLUID . >
NOTE: Make sure there are no ATF leaks in joints between the transmission, radiator, pipes, and hoses.