Planetary Gear And Low Clutch

WARNING: This page is about a different variant/trim than selected.

Remove the snap ring from low clutch drum.

Fig 1: Identifying Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Take out the front planetary carrier.

Fig 2: Identifying Front Planetary Carrier
Courtesy of SUBARU OF AMERICA, INC.
Take out the rear sun gear.

Fig 3: Identifying Rear Sun Gear
Courtesy of SUBARU OF AMERICA, INC.
Take out the rear planetary carrier, washer and thrust needle bearing.

Fig 4: Identifying Rear Planetary Carrier, Washer And Thrust Needle Bearing
Courtesy of SUBARU OF AMERICA, INC.
Take out the rear internal gear.

Fig 5: Identifying Rear Internal Gear
Courtesy of SUBARU OF AMERICA, INC.
Remove the snap ring from low clutch drum.

Fig 6: Identifying Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Compress the spring retainer and remove the snap ring from the low clutch drum using ST1 and ST2.
ST1 498627100 SEAT

ST2 398673600 COMPRESSOR

Fig 7: Identifying Spring Retainer And Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Remove the one-way clutch. < Ref. to REMOVAL , AT Main Case. >
Install the one-way clutch inner race to the low clutch drum, and then apply compressed air to remove the low clutch piston.

Fig 8: Identifying Low Clutch Piston
Courtesy of SUBARU OF AMERICA, INC.
Remove the one-way clutch inner race.
Remove the one-way clutch after taking out the snap ring.

Fig 9: Identifying One-Way Clutch
Courtesy of SUBARU OF AMERICA, INC.
Remove the needle bearing after taking out the snap ring.

Fig 10: Identifying Needle Bearing
Courtesy of SUBARU OF AMERICA, INC.