High Clutch And Reverse Clutch

WARNING: This page is about a different variant/trim than selected.

Remove the snap ring, and then take out the retaining plate, drive plate and driven plate.

Fig 1: Identifying Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Remove the snap ring, and then take out the retaining plate, drive plate and driven plate.

Fig 2: Identifying Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Using the ST1 and ST2, remove the snap ring.
ST1 398673600 COMPRESSOR

ST2 498627100 SEAT

Fig 3: Identifying Compressor And Seat
Courtesy of SUBARU OF AMERICA, INC.
Take out the clutch cover, spring retainer, high clutch piston and reverse clutch piston.

Fig 4: Identifying Clutch Cover, Spring Retainer, High Clutch Piston And Reverse Clutch Piston
Courtesy of SUBARU OF AMERICA, INC.
Remove the seal ring and lip seal from the high clutch piston and reverse clutch piston.

Fig 5: Identifying Seal Ring And Lip Seal
Courtesy of SUBARU OF AMERICA, INC.