LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls - Engine (Diagnostics) (H4SO)) >> Drive Cycle >> Procedure >> Drive Cycle E

Drive Cycle E

WARNING: This page is about a different variant/trim than selected.
  1. Make sure that the battery voltage is more than 10.9 V.
  2. Perform the Clear Memory Mode. < Ref. to CLEAR MEMORY MODE . >
  3. Drive the vehicle for the distance equal to the fuel of 30 (7.9 US gal, 6.6 Imp gal).
    NOTE:
    • It is acceptable to drive the vehicle intermittently.
    • Do not disconnect the battery terminals while diagnosing. (Data will be cleared by disconnecting the battery terminals.)
DTC CHART

DTC Item Condition
P0461 Fuel Level Sensor "A" Circuit Range/Performance -