DTC P0420 Catalyst System Efficiency Below Threshold (Bank 1)
WARNING: This page is about a different variant/trim than selected.
DTC DETECTING CONDITION:
- Detected when two consecutive driving cycles with fault occur.
- GENERAL DESCRIPTION < Ref. to DTC P0420 CATALYST SYSTEM EFFICIENCY BELOW THRESHOLD (BANK 1) , Diagnostic Trouble Code (DTC) Detecting Criteria. >
TROUBLE SYMPTOM:
- Engine stalls.
- Idle mixture is out of specifications.
CAUTION:
After repairing or replacing the defective part, perform the Clear Memory Mode < Ref. to
OPERATION , Clear Memory Mode. > and Inspection Mode < Ref. to
PROCEDURE , Inspection Mode. >.
WIRING DIAGRAM:
DIAGNOSIS PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK ANY OTHER DTC ON DISPLAY. | Is any other DTC displayed? | Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)". < Ref. to
LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >
NOTE:
In this case, it is not necessary to inspect DTC P0420.
|
Go to step 2. |
2 CHECK HARNESS BETWEEN ECM AND REAR OXYGEN SENSOR CONNECTOR.
|
Is the resistance less than 1 Ω? | Go to step 3. | Repair the open circuit of harness between ECM and rear oxygen sensor connector. |
| 3 CHECK HARNESS BETWEEN ECM AND REAR OXYGEN SENSOR CONNECTOR. Measure the resistance between rear oxygen sensor harness connector and chassis ground. Connector & terminal (B135) No. 1 - Chassis ground: |
Is the resistance less than 1 Ω? | Go to step 4. | Repair the open circuit between ECM and rear oxygen sensor connector. |
| 4 CHECK EXHAUST SYSTEM. Check for gas leaks or air suction caused by loose or dislocated nuts and bolts, and open hole at exhaust pipes.
NOTE:
Check the following positions.
|
Is there any fault in exhaust system? | Repair or replace the exhaust system. < Ref. to GENERAL DESCRIPTION . > | Go to step 5. |
| 5 CHECK CATALYTIC CONVERTER. | Is there damage on rear face or front face of catalytic converter? | Replace the catalytic converter. < Ref. to FRONT CATALYTIC CONVERTER . > | Contact the SOA service center. |