Enable Condition
WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
ENABLE CONDITION REFERENCE CHART
| Secondary Parameters | Enable Conditions |
|---|---|
| Battery voltage | > 10.9 V |
| Atmospheric pressure | > 75.1 kPa (563 mmHg, 22.2 inHg) |
| Engine coolant temperature | ≥75°C(167°F) |
| Catalyst warm-up counter (Map 2) | ≥8800 |
| Misfire detection every 200 rotations | < 5 times |
| Sub feedback | In operation |
| Evaporative system diagnosis | Not in operation |
| Time of difference (< 0.10) between actual and target lambda | 1000 milliseconds or more |
| Vehicle speed | ≥ 70 km/h (43 MPH) |
| Amount of intake air | 10 ←→ 40 g (0.35 ←→ 1.41 oz)/s |
| Rear oxygen output change from lower than to higher than 600 mV | Experienced after fuel cut |
| Load change absolute value | < 0.02 g (0.007 oz)/rev |
| Total time of canister purge operation | ≥ 5 sec. |
| Learning value of evaporation gas density | ≤0.2 |
| After engine starting | ≥ 205 sec. |
Map 2
Add the following value every 512 milliseconds.
EVAPORATION GAS DENSITY
| Intake amount of air (g(oz)/s) | 0(0) | 3.2 (0.113) | 6.4 (0.226) | 9.6 (0.339) | 12.8 (0.451) | 16 (0.564) | 19.2 (0.677) | 22.4 (0.790) | 25.6 (0.903) | 28.8 (1.016) | 32 (1.129) | 35.2 (1.242) |
| Total value for warm-up counter | -19 | -8 | 11 | 19 | 30 | 44 | 61 | 81 | 104 | 130 | 159 | 161 |