Section 65 (Cooling System (H6DO)): Thermostat: Installation
WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
- Install a gasket to thermostat.NOTE: Use a new gasket.
- Install the thermostat and thermostat cover.NOTE: The thermostat must be installed with the jiggle pin facing to the up side.
Tightening torque:
6.4 N.m (0.65 kgf-m, 4.7ft-lb)
- Connect the radiator hose to thermostat cover.
- Install the under cover.
- Lower the vehicle.
- Fill engine coolant. < Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant. >