LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Lubrication (H6DO)) >> Oil Cooler >> Installation

Oil Cooler: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the oil cooler to oil pan upper with oil cooler connector.

    Tightening torque: 

    T: 54 N.m (5.5 kgf-m, 40 ft-lb) 

    NOTE: Use new O-rings.
    Fig 1: Identifying Oil Cooler Connector, Oil Cooler And O-Ring
    G05018952
  2. Install the oil filter. < Ref. to INSTALLATION , Engine Oil Filter. >
    Fig 2: Locating Oil Filter
    G05018950
  3. Connect the water hose.
    Fig 3: Locating Water Hose On Oil Cooler
    G05018949
  4. Install the water pipe onto engine.

    Tightening torque: 

    6.4 N.m (0.65 kgf-m, 4.7 ft-lb) 

    Fig 4: Locating Water Pipe
    G05018948
  5. Refill the engine oil. < Ref. to REPLACEMENT , Engine Oil. >
  6. Fill engine coolant. < Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant. >
  7. Check the engine oil level. < Ref. to INSPECTION , Engine Oil. >
scientia non olet · About LEMON Manuals