LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Engine Controls - Engine (Diagnostics) (H6DO)) >> Subaru Select Monitor >> Operation >> How To Use The SUBARU Select Monitor

How To Use The SUBARU Select Monitor

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the Subaru Select Monitor kit. < Ref. to PREPARATION TOOL , General Description. >
    Fig 1: Identifying Subaru Select Monitor Kit
    G04998013
  2. Connect the diagnosis cable to the Subaru Select Monitor.
  3. Insert the cartridge to the Subaru Select Monitor. < Ref. to PREPARATION TOOL , General Description. >
    Fig 2: Inserting Cartridge Into Subaru Select Monitor
    G04998014
  4. Connect the Subaru Select Monitor to the data link connector.
    1. Data link connector is located in the lower portion of instrument panel (on the driver's side).
      Fig 3: Locating Data Link Connector
      G05017015
    2. Connect the diagnosis cable to the data link connector.
    CAUTION: Do not connect any scan tools except Subaru Select Monitor or general scan tool.
  5. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
    Fig 4: Identifying Power Switch
    G04989876
  6. Using the Subaru Select Monitor, call up DTCs and data, then record them.
scientia non olet · About LEMON Manuals