LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Engine Controls - Engine (Diagnostics) (H6DO)) >> Read Diagnostic Trouble Code (DTC) >> Operation >> SUBARU Select Monitor (Normal Mode)

SUBARU Select Monitor (Normal Mode)

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
  2. On the «System Selection Menu» display screen, select {Engine Control System} and press the [YES] key.
  3. Press the [YES] key after the information of engine type has been displayed.
  4. On the «Engine Diagnosis» screen, select the {DTC Display}, and then press the [YES] key.
  5. On the «Diagnostic Code(s) Display» screen, select the {Current Diagnostic Code(s)} or {History Diagnostic Code(s)}, and then press the [YES] key.
    NOTE:
    • For detailed operation procedure, refer to the "Subaru Select Monitor Operation Manual".
    • For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)".

    < Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >

scientia non olet · About LEMON Manuals