Drift Diagnosis
WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure that the engine coolant temperature at engine starting is less than 30°C (86°F).
- Start the engine, and warm it up until engine coolant temperature increases over 95°C (203°F).
- After the engine has reached the state of procedure 2), idle the engine for more than 10 minutes.
NOTE:
Do not disconnect the terminal of battery during diagnosis. (Data will be cleared when disconnecting the battery terminals.)
DTC CHART
| DTC | Item | On condition |
|---|---|---|
| P0111 | Intake Air Temperature Sensor 1 Circuit Range/Performance | - |