LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Engine Controls - Engine (Diagnostics) (H6DO)) >> Drive Cycle >> Procedure >> Drive Cycle E

Drive Cycle E

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure that the battery voltage is more than 10.9 V.
  2. Perform the Clear Memory Mode. < Ref. to CLEAR MEMORY MODE . >
  3. Drive the vehicle for the distance equal to the fuel of 30 (7.9 US gal, 6.6 Imp gal).
NOTE:
  • It is possible to drive intermittently.
  • Do not disconnect the terminal of battery during diagnosis. (Data will be cleared when disconnecting the battery terminals.)
DTC CHART

DTC Item On condition
P0461 Fuel Level Sensor "A" Circuit Range/Performance -